Refresh the firmware

From WRTnode Wiki Site
Jump to: navigation, search
This page contains changes which are not marked for translation.

Other languages:
English 100% • ‎中文(中国大陆)‎ 100%

Flash pleasure in it, but the fun and risk coexist.

1:Prepare the firmware

You can refer to the document compile WRTnode firmware to compile the firmware. you can also directly download the WRTnode official firmware(linux kernel 3.10.44) or updated version of the firmware(linux kernel 3.14.18).

2: To refresh the firmware, we provide two kinds of commonly used flash method

Method 1:PC even WRTnode wifi or PC via Ethernet cable connected with WRTnode,After the connection is successful, open the browser,Input i.wrtno.de or 192.168.8.1 in the address bar,Enter the openwrt luci interface, input your password to log in (If did not change the password, the password is empty).

In the System->Backup/Flash Firmware , to refresh the Firmware,Select the firmware is located,Click to refresh the firmware.

Erefresh.png

Patience wait a few minutes, don't power off or manually disconnect wifi in the process. Will appear after the completion of WRTnodexxxx and connected again.

Method 2: PC even WRTnode wifi or a PC through the Ethernet cable connected with WRTnode, use winscp software to PC firmware, upload wrtnode board.

Put the firmware in wrtnode /tmp directory. If you are a Linux system, you can directly use the scp command to copy the firmware to the development board.If you are a windows system, you can use the winscp to copy the firmware to the development board. Selected in the putty "SSH" landing WRTnode.

At the command line to perform the following command:

root@OpenWrt:~#mtd write -r openwrt-ramips-mt7620n-wrtnode-squashfs-sysupgrade.bin firmware

Write flash:

Refresh3.png

Restart:

Refresh4.png

Patience wait a few minutes, don't power off or manually disconnect wifi in the process. Will appear after the completion of WRTnodexxxx and connected again. 

If these two methods can not, you can see /saving your wrtnode.

3 :apcli configuration

the firmware after brush, about apcli configuration here